Installation step

1¡¢Pack into and lead the post. Is it focus shelf fasten nut , direction insert in and lead the post in accordance with the instructions of arrow point to relax at first.
2¡¢Install the ring of orientating. Is it orient ring fasten nut , direction pack the ring of orientating into in accordance with the instructions of arrow point to relax, rotate the ring of orienting and fasten the nut to make it fixed in the corresponding height after packing into.

3¡¢Assemble wholly. ¢ÙRelax and focus the shelf and fasten the nut. ¢ÚIs it focus support to pick up, is it lead post aim at chassis corresponding nut , rotate and lead the post to make. ¢ÛIs it focus shelf fasten nut is it focus shelf to be regular to make to rotate

4¡¢Connect the body connecting wire of the infrared lamp¡£¢ÙAim the connecting wire plug at inserting in the connecting wire socket of the infrared lamp¡£¢ÚRotate the fixed screw right.
Body connecting wire of the infrared lamp

Operation method
1¡¢Boot.

¢ÙCheck the power source,wind the plug.
¢ÚTurn on the power source.Don¡¯t use until pass check.Pand will display enactment value.When last time used.
¢ÛInstallation the repair shell.Fix the line on the strip rack.Screw the light system height.Keep 20-30mm between light and welder machine.
¢ÜAccording to measurement of welder piece.Proprictily screw temperature.from60¡æ-460¡æ.When you strip 15¡Á15mm piece.Choice temperature 240-350¡æ.When you strip 30¡Á30mm piece.Choice temperature 250-460¡æ.The temperature come up to 460¡æ.The light system will shoot straightly.Please pay more attention to yourself control time.avoid burn out.
¢ÝScrew focus.The light system smallest diameter is 15mm .the biggest is 30mm.Normally keep 20-30mm.
¢ÞTurn on the two switches.They control warm-up plate and light system.
2¡¢Dismantle and weld¡£
¢ÙRegulate temperature , make the chip focus
¢ÚAfter suitable for timing, the tin is clicked and melted, take out the chip¡£
3¡¢Weld the chip¡£
¢ÙClean the pad¡£
¢ÚCoating help solder flux (should not thick too , can have first more thin ) and soldering tin ball¡£

¢ÛWait to help the solder flux to volatilize into the flux, heat and totally melt to the tin ball , place correctly with the clip , aim at the chip to weld into the position.

Caution!
1¡¢After use , imprison power immediately , make sure the light body cooling down,and place it in safety.After turning off the power switch
2¡¢Keep the blowing way without hindered, the light body is clean.
3¡¢The support in good time is polished with the oil to lead the post , focus
4¡¢Disconnect the plug when you don¡¯t use the it for a long time.
5¡¢Operate carefully, take care¡£